Husqvarna W 65P Manual De Usuario página 8

1. Set the fuel valve lever (A) to ON position.(Fig. 27)
2. Set the choke lever to the correct position.
a) If the engine is cold, close the choke (B).(Fig. 28)
b) If the engine is warm, open the choke(B). (Fig. 29)
3. Apply approximately 1/3 throttle (C).(Fig. 30)
4. Pull the starter grip(E) slowly until you feel resistance.
(Fig. 31)
5. Pull the starter grip quickly and with force until th
engine starts.
6. Move the starter rope back slowly into its initial
position to prevent damage to the product.
7. If the engine is cold, move the choke gradually as the
engine becomes warm.
To set the engine speed and pump output
1. When the throttle handle (A) is at the turtle position,
the engine is at idle speed and the pump output is
low.(Fig. 31)
2. Move the throttle handle towards the rabbit
position to increase the engine speed and pump
WARNING
safety chapter before you do maintenance
on the product.
Maintenance schedule
Maintenance
Do a check of the engine oil level.
Replace the engine oil.
Clean the air filter, replace it if it is necessary. .
Clean the external part of the spark plug.
Remove it and check the electrode gap.
Adjust the distance to 0.7±0.08mm.
Replace the spark plug
Clean the sediment cup
Do a check and adjust the engine speed.
Do a check and adjust the valve clearance.
Clean the combustion chamber.
Clean the fuel tank and fuel filter.
Do a check of the fuel tube.
Do a check of the impeller and impeller
clearance.
Do a check of the pump inlet valve.
Maintenance
:
Read and understand the
output.(Fig. 32)
3. When the throttle handle is at the rabbit position,
then engine is at full speed and the pump output is
high.(Fig. 32)
Note:
The pump output is related to the engine speed
and is adjusted by the throttle handle.
To stop the produc
e
Decrease the engine speed with the throttle handle(A).
(Fig.33)
Press the stop button(B) (Fig.33)
1.
2.
Set the fuel lever(C) to the OFF position.(Fig. 34)
3. After the product is stopped and becomes cold,
clean the product
Note: The product is not able to restart within 30
seconds for special design of protection.
*
Clean at a more regular interval if the product is used in
conditions with much dust.
** Maintenance is only necessary if operation problems
occur. Speak to an approved servicing dealer.
Daily
maintenance
20 hours
before
or each
operation
month
X
X
X
After each 500hours or 2 years.
After each 500hours or 2 years.
t
WARNING:
If an emergency occurs,
immediately press the stop button.
.
Maintenance interval
50 hours 100 hours
or each 3 or each 6
months months
X *
X
X**
300
hours or
each year
X
X
X**
X**
X**
X**