Publicidad
Idiomas disponibles
Idiomas disponibles
/
Release the handle by pressing down on
the handle release pedal with your foot and
pulling back and down on the handle with
your hand°
To start the vacuum cleaner, step on the
ON/OFF switch located on the back of the
vacuum.
To stop the vacuum cleaner, step
on the switch a second time..
On/Off
Switch
/
Handle
Release
Pedal
eJquJoJle
uoo sos!d
ap UOlOtsod
el e_seH
opeuJanb .JOlt
e£ enb JeSt
a[a la e_,oJj e_
e_,sa ap ao£q (
Jo_loeles lee
Jod
e!a!JdE_ I
'Jo:loafasla Je^
'EtSJJO0 :
eljege
unBu!ua]uean
ua opueuo_ou
Bare floor
setting:
Slide the carpet/bare
floor selector all the way back and down
toward the bottom of the nozzle until it locks
into place.
In this position the brush assembly does not
revolve° This setting should be used for
cleaning
hardwood
and tile floors and when
any attachments
(tools)
are used
Carpet setting:
Slide the selector all the
way forward
and up to the carpet
position..
In this position the brush assembly will turn°
When carpets are being cleaned the selec-
tor should be in this position°
Attention:
Refer to your carpet manufac-
turers cleaning
recommendations.
Some
more delicate carpets may require that they
be vacuumed
with the agitator turned off, to
prevent carpet damage.
CAUTION
Do not allow vacuum
cleaner
to
remain
in one spot for any length
of time when the agitator
is turn-
ing, Damage
to carpet
may occur°
Note:
For longer belt life, turn vacuum off
before moving selector, otherwise
make sure
the selector is pushed fully and quickly
as
possible
to the desired position_ Failure to
do so can cause the belt to rub on the
selector shaft and may result in the belt
becoming
hot and creating a burning rubber
smell.
Carpet/Bare
Floor Selector
To Bare
Position
To Carpet
Position
Publicidad
