Publicidad
Idiomas disponibles
Idiomas disponibles
28
Maintenance and Service
4.3 Error Codes
The list below contains all the error codes of the welding machines. Consider the error codes related with your machine.
EN
Error Code
E01
E02
E03
E04
E05
E06
E07
E08
E09
E10
E11
E12
E13
USER MANUAL
Error
• The uptime of your machine may have
been exceeded
• Fan may not be working
Thermal
Protection
(Primary)
• The front of the air inlet-outlet ducts
may be blocked
• The machine working environment
may be too hot
Mains Voltage
• Mains voltage may have decreased
Low
Mains Voltage
• Mains voltage may have increased
High
Current / Voltage
• There may be a hardware error
Reading Error
Temperature Sensor
• There may be a hardware error
Reading Error
Water Cooling
• There may be an error in the water
Unit Error
cooling unit
System Error
• There may be a hardware error
Torch Connection
• The torch or torch connections
Error
may be faulty
System Error
• There may be a hardware error
Wire Feeder Error
• There may be an error in wire feeding
• Allow the machine to cool down by
Cause
• If the problem continues, contact the
• Check visually whether the fan is
• If the problem continues, contact the
• Open the front of the air ducts
• If the problem continues, contact the
• Make sure that the working
• If the problem continues, contact the
• Check the mains connection cables
• Check the mains connection cables
• Contact the authorized service
• Contact the authorized service
• Check water cooling unit connector
• Make sure there is water circulation
• If the problem continues, contact the
• Contact the authorized service
• Check torch and torch connections
• If the problem continues, contact the
• Contact the authorized service
• Check wire basket, reel / reel press
• If the problem continues, contact the
monoCUT 45ix / monoCUT 45i
Solution
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
working or not
authorized service
authorized service
environment of the machine is not
excessively hot or stuffy
authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and torch inlets/outlets
authorized service
authorized service
and torch connections
authorized service
www.magmaweld.com
Publicidad
