Marmitek Speaker Anywhere 650 Manual De Instrucciones página 13

10 Frequently asked questions (FAQs)
The LED remains off after the transmitter / receiver is switched on
Check the power outlet and the power supply.
Check the power supply's voltage.
No audio at receiver side
Check that the blue LED is lit continuously.

Adjust the receiver's volume control.

Does the speaker have a signal?

Audio is distorted or too low
Adjust the volume control of the set until no more clipping occurs.

Adjust the volume control of the receiver until no more clipping occurs.

Do you have any other questions that have not been resolved by the
above information? Please go to
11 Notification
11.1 Declaration of Conformity
Hereby, Marmitek BV declares that this Speaker Anywhere 650™
is in compliance with the essential requirements and other relevant
provisions of the following Directives:
Directive 2014/53/EU of the European Parliament and of the Council of 16
April 2014 on the harmonisation of the laws of the Member States relating to
the making available on the market of radio equipment and repealing
Directive 1999/5/EC.
Directive 2011/65/EU of the European Parliament and of the Council of 15
November 2017 amending Directive 2011/65/EU on the restriction of the use
of certain hazardous substances in electrical and electronic equipment.
You can read the Declaration of Conformity at
https://marmitek.com/pages/declarations-of-conformity/
Marmitek BV - PO Box 4257 - 5604 EG Eindhoven
Speaker Anywhere 650™
www.marmitek.com
The Netherlands
13