Description; Features; Attachment - EuroLite DMX Split 4 Manual Del Usuario

When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

DESCRIPTION

Features

4-fold DMX-splitter
Dmx distributor with one input and four output • Absolute electric isolation between input and output, or
between output and output • Two types of DMX connector (3 pin & 5 pin) for each individual channel • Every
DMX output features an independent driver, data & data-indicator • DMX switch is incorporated allowing
isolation from the malformation caused by DMX input • Input and output with a set of respective power
supply and 500 mA internal fuse

Attachment

Before attaching the product, make sure that the installation area can hold a minimum point load of 5 times
the product's weight.
The product must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the product is installed absolutely planar by using a water-level.
The product must be installed out of the reach of people.
The product must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
12/24 00026253.DOC, Version 1.1