Cleaning And Maintenance; Danger To Life; Technical Specifications - EuroLite DMX Split 4 Manual Del Usuario

Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Note: After switching on, the device will automatically detect whether DMX 512 data is received or not. If the
data is received, the red and green LEDs on the front of the device will flash. If there is no data received at
the DMX-input, the red and green LEDs will not flash.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX 512-output:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 10.11.2008 ©
International
L
N

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
20 W
3-pin or 5-pin XLR-connector
325 x 190 x 80 mm
3 kg
14/24 00026253.DOC, Version 1.1