Publicidad
Idiomas disponibles
Idiomas disponibles
FUNCTIONAL DESCRIPTION
3
2
1
1. Volume down
2. Power/Pair
3. Stereo AUX jack
4. USB power outlet
5. Fuel gauge
6. Volume up
SYMBOLOGY
V
Volts
A
Amps
Hz
Hertz
Direct Current
Read Operator's Manual
Federal Communications Commission
UL Listing for Canada and U.S.
SPECIFICATIONS
Cat. No. ..................................................... 2592-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
USB Ouput Volts............................................. 5 DC
USB Output Amps ..............................................2.1
FCC ID ................................. 2ADDWSPEAKER-12
Recommended Ambient
Operating Temperature ......................0°F to 125°F
4
5
8
6
7
7. Indicator light
8. Hang hook
9. Battery bay
10. Bass port
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
The fuel gauge will show the remaining battery
charge for 2-3 seconds after turning on the speaker.
To signal the end of charge, 1 light on the fuel gauge will
blink slowly until the speaker shuts off automatically.
Battery Pack Protection
To protect the life of the battery pack, the speaker will
9
shut off when the battery's charge becomes too low.
If this happens, remove the battery pack and charge
10
it according to the charger's instructions.
Connecting an Auxiliary Device
Connect an MP3 player, CD player, or other audio
device directly to the speaker using the stereo aux-
iliary jack AUX IN.
This outlet can be used to charge a cell phone, power
an MP3 player or any other device that uses less than
2.1A of DC electrical current.
NOTE: Any device that uses more than 2.1 A of DC
electrical current will trip a self-resetting overload
and disable the output.
WARNING
to rain or moisture.
and Connecting to Bluetooth
Press the Power/Bluetooth
speaker on and off.
• If no Bluetooth device was previously paired,
Bluetooth pairing will begin automatically and the
indicator light will flash continuously.
• The speaker will continue to search for a signal for
10 minutes.
• To manually pair a device, turn on the speaker and se-
lect "M12 Speaker" on the Bluetooth capable device.
• Once paired, the speaker will automatically reconnect
to the same device when the speaker is turned on.
• To pair the speaker to a different device, press
and hold the power/pair button for 3 seconds un-
til the indicator light flashes. It will then be in pair
mode and can be connected to a different device.
• Once the device has successfully paired with the
speaker, use the device controls to move through
tracks and control volume.
Use the
to increase or decrease the volume.
NOTE: To control the volume using the device's
controls, first turn the speaker volume to max (a
beep will sound).
3
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Fuel Gauge
USB Power Outlet
OPERATION
To reduce the risk of fire or electric
shock, do not expose this speaker
Turning On/Off
button to turn the
Volume
Publicidad
