Advanced Networking Application With Bms Integration; Display Messages - Leviton Luma-Net NP00G Manual Del Usuario

7.3 ADVANCED NETWORKING APPLICATION WITH BMS INTEGRATION

Ethernet
Luma Graphics
Luma Scheduler
Power
SectorNet
Luma-Net
LumaCAN
Note: LumaCAN Gateway used with GreenMAX only may use bacnet/IP direct to GreenMAX Cabinet

8. DISPLAY MESSAGES

1. Bootloader XX.YY - bootloader application is running, XX.YY indicates the application version.
2. Reading File - reading the programming file from the SD card.
3. Checking File - validating file against flash.
4. Interactive - waiting for commands from the serial terminal.
5. Rebooting - rebooting device.
6. Launch App - starting application.
7. Burn Internal - reprogramming application.
8. Erase External - reprogramming application.
9. Burn External - reprogramming application.
10. Init Hardware - initializing hardware.
11. Init File System - initializing file system.
12. Init Ethernet - initializing Ethernet.
13. Waiting for DHCP - waiting for DHCP to give an address.
14. Configuring - configuring subsystems.
15. Ready - startup sequence complete.
16. Start Fail - the startup configuration script could not be read from the SD card.
17. LN:xxx CAN:yyy - Luma-Net
18. No Config - no configuration stored.
19. WatchdogTimeout SSSS - subsystem SSSS failed where SSSS is a name.
20. Factory Defaults Total Clear - a "Total Clear" press sequence was detected and executed.
21. Factory Defaults Configuration - a "Configuration Clear" press sequence was detected and executed.
22. Rebooting...5 - will reboot in 5 seconds (Continues to count down until it reaches 1 Second).
23. Boot Failed...Retrying - this is the result of the device not completing the startup sequence after ten minutes.
+24vdc
Luma-Net
NPDLR-000
LUMA-NET 3
SAPPHIRE-NET COLORNET
T R
DMX DMX
OUT IN
DMX512 OUT DMX512 IN
ACTIVE ACTIVE 10/100 RS 232
NPCDLR
a-2000
R TM
TUALATIN, OR MADE IN U.S.A.
INDUSTRIAL CONTROL EQUIPMENT LISTED
32300A R 88H9 C R
+Vac
(LN) and LumaCAN
®
Page 10
+24vac
Luma-Net
Power Supply
LumaCAN®
B
Power Ethernet Luma-Net® MS/TP A Expansion
Link/RX
Error
Reset
TX
Network Protocol Converter
NP00G
LumaCAN
Gateway
BACnet/IP
R BRIGHT FULL
PHASE LOSS FULL BRIGHT
FAN SELECT
COMMUNICATION PORTS SAVE
DMX AUXILIARY CANCEL
LUMANET CLEAR
PHASE A
CONTROL
PHASE
B
C PHASE
NORMAL BYPASS
MODULE 1
MODULE 2
MODULE 3
NORMAL BYPASS
MODULE 4
MODULE 5
MODULE 6
NORMAL BYPASS
MODULE 7
MODULE 8
Sector Ballast
MODULE 9
NORMAL BYPASS
MODULE 10
MODULE 11
Line
MODULE 12
Voltage
A2000
(CAN) address.
TM
GreenMax
LumaCAN
Cabinet
+Vac
SectorNet
+Vac
Sector
Bus Controller