Publicidad
MAINTENANCE
Cleaning the heat exchange
Leave the dryer to cool down.
Residual water may leak out, place an absorbent
cloth under the maintenance cover.
1. Unlock the maintenance cover.
2. Completely open maintenace cover.
3. Turn both locking levers towards each other.
4. Pull out the heat exchanger.
5. Flush the heat exchanger with water to remove lint;
let the water drain properly.
6. Clean the seals.
7. Re-insert the heat exchanger, the handle at the bottom.
8. Turn both locking levers.
9. Close the maintenance cover until it locks into position.
Please clean the heat exchanger approximately, once every
3 months if frequently used.
Do not damage the heat exchanger!
！
Warning!
• Clean with water only; do not use hard/sharp-edged objects!
Do not operate the dryer without the heat exchanger!
21
Publicidad
