Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEmbLY
INSTrUcTIONS (FIG. 3)
1.
Locate and remove all loose parts
from the carton.
2.
With handle oriented as shown,
align grooves in carry handle (P)
with rails on top of pressure washer
and slide into place.
3A
3.
Push as shown to further lock carry
handle into place.
3B
4.
Align slots (BB) on back of storage
rack with ribs (AA) on back of
pressure washer.
5.
Slide storage rack down until it
locks into place.
3C
AA
P
BB
6.
Remove and discard the shipping
plug (L) from the outlet (K) on the
front of the machine.
3D
OPErATING INSTrUcTIONS
PRESSURE WASHER
TERMINOLOGY
PSI: Pounds per Square Inch. The
unit of measure for water pressure.
Also used for air pressure, hydraulic
pressure, etc.
GPM: Gallons Per Minute. The unit of
measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by
PSI. GPM x PSI = CU
Detergent Injection System: Mixes
cleaners or cleaning solvents with the
water to improve cleaning effectiveness.
Water Supply: All pressure washers
must have a source of water. The
minimum requirements for a water
supply are 20 psi and 5 gallons per
minute. If your water source is a well,
the garden hose length can only be 30
ft. (9 m) max.
WARNING:
possibility of contamination always
protect
against
connected to a potable water system.
DANGER: Risk of fluid injection
and laceration. When using the high-
pressure setting, DO NOT allow
the high-pressure spray to come in
contact with unprotected skin, eyes,
or with any pets or animals. Serious
injury will occur.
•
Your washer operates at fluid
pressures and velocities high
enough to penetrate human and
animal flesh, which could result in
amputation or other serious injury.
9 - ENG
k
L
To
reduce
the
backflow
when
Publicidad
