Schwaiger UFB 801 Instrucciones De Manejo página 8

8
When your appliance reacts,
Simply press the ENTER -/-- button and stop the search.
To test whether the right setting has been found, simply press
a few buttons on the UFB 801 and check whether the functions
work correctly. If everything is OK you can now set the UFB 801
for the second appliance.
If your equipment doesn´t react oder some buttons don´t work,
Repeat steps
1.2.2 Quick code search
Your remote control fi nds the correct settings almost auto-
matically in seconds:
Switch on the appliance to be controlled.
Automatic quick search: The UFB 801 automatically sends
a different IR code each second. When your appliance reacts,
immediately press the ENTER-/-- button to confi rm the code.
With very few appliances the quick search does not work. The
search is automatically stopped if there is no reaction from the
appliance to be controlled. You should then use a different set-
ting procedure, e.g. code entry or slow search. Remember to
switch on your appliance again, e.g. DVD, if you wish to continue
the search.
Finally, test the set code by controlling e.g. your DVD
appliance. If it doesn´t work correctly repeat steps 1 to 6.
2 GENERAL FUNCTIONS
2.1 Volume Punch-Through function: To simplify operation,
the volume buttons (VOL► or VOL◄) and the MUTE button
always control the television set, when VCR and DVD are being
controlled.
2.1.1 Adjustment of ALL volume controls under a specifi c mode
You can allocate the volume control to one of the modes of the
remote control on condition that the volume control exists on
the corresponding device (e.g. control of TV sound in TV mode,
VCR, DVD).
Hold down the SETUP key until the indicator lamp (LED)
remains lit.
Release the SETUP key.
Press the MUTE key.The lamp fl ashes once.
The remote control continues the search at the point you stop-
ENTER
ped It with the
is reached the search stops automatically. The remote control
blinks quickly several times. The code last confi rmed with the
ENTER
-/-- remains stored.
to
= SETUP (3 s)
= e.g. TV
= Press once
We advice you to place your fi nger over the ENTER -/-- button
so that you can react quickly enough. Otherwise the UFB 801
transmits the next signal before you have reacted.
-/-- button. When the end of the code list
.
= Set (LED lights up red)
= Equipment selection