Descargar Imprimir esta página

Marshall AS50D Guia De Inicio Rapido página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
WARNING! SAFETY INSTRUCTIONS
Please read this manual carefully before plugging in. Follow all instructions and heed all warnings.
Warning: Please refer to full details in separate
Important Safety Instructions CATS-90009.
Warning: Before going any further, make sure
that your amplifier is compatible with your
mains electricity supply. If you have any doubt,
please seek help from a qualified technician –
your Marshall dealer can help you with this.
MAINS INPUT & FUSE
The specific mains input voltage rating that your
amplifier has been manufactured for is indicated
on the rear panel of the amplifier. Your amplifier
is provided with a detachable mains (power)
lead, which should be connected to the mains
input socket on the rear panel of the amplifier.
IMPORTANT SET UP INFORMATION
1. Ensure that the power switch is set to the
off position.
2. Connect the supplied mains (power) lead
into the mains input on the rear panel first
and then into an electricity outlet.
3. Ensure that the channel volume controls
and master volume control on the front
panel are set to zero.
4. Plug your instrument into the channel 1
input jack socket on the front panel.
5. You may also plug another instrument into
the channel 2 input jack socket, and/or a
microphone into the channel 2 microphone
jack socket.
6. Turn the front panel power switch on.
7. Turn the volume up to your preferred level
and your amplifier is ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off,
unplugged from the mains electricity supply and
all removable cables have been disconnected from
your equipment before attempting to move it.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Caution: Any changes or modifications not
expressly approved by the party
ENGLISH
2

Publicidad

loading