Publicidad
Idiomas disponibles
Idiomas disponibles
EN Bluetooth transmitter and receiver 2 in 1
Production description: AC830 is a bluetooth transmitter and
receiver with Toslink. When used as a Bluetooth transmitter, it
can transfer the music on your mobile,Walkman,TV, computer
,etc to your Bluetooth receiver, Stereo Bluetooth headphone,
and Bluetooth speakers through wireless technology.
When used as a Bluetooth receiver, it can been a stereo
Bluetooth headphone (by plugging headphone audio cable into
3.5mm port),or connecting with speaker to receive audio
signal through wireless. Please read the user manual carefully
before use the unit.
Preparation before use: when ready to use AC830, you need
fully charged of AC830, music players, mobile phones,
televisions or computer support Fiber optic interface or 3.5MM
audio interface output devices.
Product picture and function definitions:
A. Multi-function keys
B. Mode selection switch (TX: transmitter; RX: receiver)
C. Interface selector switch
(AUX: 3.5mm audio interface; SPDIF: optical interface)
D. 3.5MM audio line interface (audio input/output)
E. Optical fiber input interface F. Optical output interface
G. Micro USB charging port H. LED indicator
Specification: • Bluetooth version: V4.1, Class II,
chipset: CSR BC8670 • Frequency: 2.402GHz-2.480GHz
• Receiver/Transmitter working time: About 15h
02 I
• Charging time: Around 2 hours
• Bluetooth profile: RX:A2DP AVRCP TX:A2DP
• Passcode for supported Bluetooth: 0000, 1111, 1234, 8888
• CODEC: TX: Priority APT-X, Second SBC,
Third:APTX-LL; Fourth: FastStream RX:SBC
• Battery: 350mAH rechargeable lithium battery
• Charging supply: 5VDC,100-240V AC adapter, >300MA
• Working temperature: -10/55°C
• Net weight: Approx. 38.6g • Dimension: 60x60x18.4 mm
OPERATION: AC830 charging: 1. First time charging: Please
fully charged the model AC830 before using.
2. Charging in low power: When the red LED light is flashing
in normal use, it indicates that the AC830 is in low battery
mode and needs to be recharged (it is normal for the blue and
red LED light overlap when using in low power and charging
while working) A.Connect the charging cable to the charging
adapter (with USB output connector) or to the computer.
B. And then connect the Micro USB side to the AC830.
C. The red LED light on whiling charging, red LED off when fully
charged. D. The charging time takes about 2 hours.
AC830 working as transmitter function and LED instruction
• AC830 is through toggle switch to select the mode is
transmitter or receiver mode after powered on.In power off
status,switch to "TX" end, and long press "multi-function key"
to power on,all paired device information will be cleared in RX
mode after powered on! Please don't switch TX/RX mode
within 3 seconds after powered off, because the chipset has
not been fully powered down, the mode is maybe still keep the
same state as before powered off if you switch the mode.
I 03
Publicidad
