AUDIOCORE AC830 Manual Del Usuario página 3

• AC830 can store 4 devices information used as
a transmitter, the exceed device information will be replaced by
new device information (Why is store 4? Because the AC830
will re-connect all the paired devices after powered on, it will
take long for too many devices)
• AC830 automatically re-connection time: 7 seconds for the
unit has 1 paired record, 12 seconds for the unit has 2 paired
records,17 seconds for the unit has 3 paired records, 22
seconds for the unit has 4 paired records.
1. Power on: In off state, press MFB around 3 seconds, Blue
LED flashes twice, AC830 is powered on. (If AC830 did not
connect with any device, it could enter into pairing mode
quickly with Blue LED flashes after power on)
2.Power off: In on state, press MFB around 3 seconds, Red
LED flashes twice ( if release after Red LED immediately, Red
LED may only flashes once), AC830 power off. Please re-power
on the unit after power off the unit 3 seconds later since the
voltage of the chipset may not disappear totally.
3. Pairing mode: Power on the unit, double click the MFB, the
Blue LED flashes quickly to enter pairing mode.
4. Clear up the pairing list: Power off with the current working
mode(TX or RX), 3 seconds later, switch to the other working
mode, then power on, the pairing information for the former
mode will be cleared up.
5.Re-connect with all the connected device: Power on the
unit (using two connections simultaneously), short press MFB
to connect all the connected device automatically, but it only
support two devices connection simultaneously, prioritize the
latest two connected devices, successfully connected, AC830
04 I
is solid blue. If AC830 could not connect with any device in
22 seconds (This is up to how many paired device AC830
stored), it will enter into pairing mode. When used as Bluetooth
transmitter, it support two connected devices transfer Audio
simultaneously.
6. Power off automatically: The AC830 will power off
automatically when the battery voltages lower than 3.1V.
7. Pairing status: Blue Led light flash quickly used as
bluetooth transmitter status.
8. No connection standby status: Blue Led light flash once
every second in no connection standby status
9. Connected standby status: Blue Led long light in
connected standby status
10. Low battery status: Low battery status (RX):red LED
flashes once every one second,and it will cover other Led light
(Charging immediately or power off will remove this status).
11. Interface switching: In off state or working state, switch
between AUX and SPDIF through the toggle switch.
12. AC830 working while charging: When need to use the
AC830 for long time, due to the limited built-in battery usage
time, it allowed to connect the charging power supply (DC 5V
?300mA, when the battery is low or when the power supply of
poor quality may cause the current sound appears); operation
steps:connect the charging power and then power on
AC830,(because the chipset will reset operation when insert
charging power supply,can resume normal use when AC830
software crashes)
Note: it is not recommend to use this function while charging,
otherwise it may affect battery life.
I 05