Publicidad
Idiomas disponibles
Idiomas disponibles
m int ning
©UF
Keeping your dishwasher clean improves its performance, reduces unnecessary
repairs, and lengthens its life.
CLEANING
THE EXTERIOR
It's best to clean spills on the outside of your dishwasher
as they occur. Use a soft, damp cloth on the
control
panel to gently wipe away spills and dust. Do not use benzene,
wax, thinner, chlorine bleach,
or
alcohol.
These materials
may discolor
the door panel and other outer surfaces
and cause stains. Do not
clean the dishwasher
by sprinkling
water over it and avoid letting water
come into contact
with any of the
electrical
parts.
lf your dishwasher
has a stainless steel door panel, you can clean it with a stainless
steel cleaner for
Home Appliances
or similar product
using a clean, soft cloth.
CLEANING
THE iNTERIOR
Clean the interior of your dishwasher
periodically
to remove any dirt or food particles. Wipe the inside of
the dishwasher
and the inner part of the door with a wet dishcloth.
We recommend
filling the detergent
dispenser
with dishwasher
soap, and then running the dishwasher
empty periodically
using the Self Clean
option. To keep the cutlery
pad clean, turn it over. This will keep your dishwasher
clean.
If white spots and odor are still present
in your dishwasher,
run the Self Clean
option with the dishwasher
empty and without
detergent
until it flushes. Then, interrupt the cycle and put an 8 ounce cup of white
vinegar
into the lower basket.
Close the dishwasher
and let the cycle finish.
Do not remove the tub front seal (the long rubber
seal enclosing
the opening
of the dishwasher).
CAUTION
CLEANING
THE NOZZLES
If your dishwasher
does not seem to be cleaning
adequately
or the nozzles seem clogged,
you can clean
each of the nozzles. When removing
the nozzles, take care as they may break.
Upper nozzle
t.
Pull the upper rack towards
the front
2.
Check whether
the nozzle holes are
clogged
by food particles.
3.
If cleaning
is needed,
remove the nozzle.
4.
To remove the nozzle, unfasten and remove
the nut, and then remove the nozzle.
5.
Clean the nozzle, re-insert it, and fasten the
nut.
6.
When fastening
the nut, turn it firmly by
hand.
7. Check whether
the nozzle is engaged
correctly
by rotating it by hand.
English o 22
I
D1,*TSOH9950
00149A
04
EN
141224indd
S_,c5:22
Publicidad
