Publicidad
Idiomas disponibles
Idiomas disponibles
_
_ _ii
i iii _
i
_ii
iii
iii
Does not dry
dishes
wee
There is no rinse aid in the
dispensen
The temperature
of the water
is low when the dishwasher
is
running.
Too many dishes have been
loaded.
Glasses and cups with
concave
bottoms
hold water.
Check the dispenser
and add rinse aid.
Use a liquid type rinse aid.
Connect
the water supply
line to a hot water
supply.
Use rinse aid with the Sanitize option.
Proper loading of items can affect drying.
Load your dishes as recommended.
(See page 16.)
After finishing the cycle, empty the lower rack
first and then the upper rack. This will prevent
This water may spill onto other
items when unloading.
Water was left over from an
incomplete
cycle.
The Drain Hose is obstructed.
Has a bad odor.
The dishwasher
is not used
daily or soiled dishes are left in
unit too long.
Sound is generated
when the
dispenser
cover is open and
the drain pump is operating
in
an early stage.
The dishwasher
is not level.
Is tee noisy.
Foreign material (a screw, a
plastic piece) is in the pump
chamber.
There is a 'chopping'
sound
because
a nozzle is bumping
against the dishes.
The nozzle hole is clogged
water dripping
from the upper rack onto the
dishes in the lower rack.
Insert detergent
without
loading
dishes, and run
the Normal cycle to clean the dishwasher.
Contact
a qualified
service technician
to remove
any obstruction
from the drain hose.
With the dishwasher
empty and no detergent,
place a glass with 8 ounces
of vinegar upright
into the lower rack, and then run a Normal cycle.
This is normal operation.
Ensure the dishwasher
is level.
Contact
a qualified
service technician
to remove
foreign material from the pump chamber.
Rearrange
the dishes.
Clean the nozzle hole.
Does not have a
smoothly
rotating
n0zzle_
Water
won't
pump out of the
dishwasher.
Has a bent
upper
rack after loading
dishes:
with food particles.
The nozzle is blocked
by a
dish or pot and cannot rotate.
The drain is clogged.
The dishes are not loaded
properly.
See pages 22 and 23.
After placing the dishes into the racks, rotate the
nozzles by hand to check
whether
any of the
dishes interfere with them.
Contact
a qualified
service technician
to remove
any obstruction
from the drain hose and drain
hole inside the sump. After that check the drain
pump operation.
Load your dishes as recommended.
(See page 16.)
English o 27
I
D1,*TSOH9950
00149A
04
EN
141224indd
S_,c7:27
Publicidad
