LG DLEX2501W Guía Del Usuario E Instrucciones De Instalacion página 20

INSTALLATION INST UCTIONS
cONNEcTiNG ELEcTRic DRYERS {cont.)
USA ONLY
, WARN|NG:
• Connect the power cord to the terminal block. Each colored wire should be connected
to same color screw. Wire color indicated on manual is connected to the same color
screw in block. Failure to follow these instructions may result in a short or overload.
• Grounding through the neutral conductor is prohibited for: (1) new branch-circuit
installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local
codes prohibit grounding through the neutral conductor.
Four-wire Connection for Electric Dryers: Direct wire
• A 4-wire connection is required for all mobile
and manufactured home installations, as well
as all new construction after January 1, 1996.
A UL-listed strain relief is required.
Use UL-listed 4-wire #10 AWG=minirnum
copper conductor cable.
Allow at least 5 ft (1.5 m) length to allow for
removal and reinstallation of the dryer.
Ground Wire
(12.7 cm) ./
J_
Remove 5 in. (12.7 cm) of the outer covering
from the wire. Remove 5 inches of insulation
from the ground wire. Cut off approximately
11/2in. (3.8 cm) from the other three wires
and strip 1 in. (2.54 cm) insulation from each
wire. Bend the ends of the three shorter
wires into a hook shape.
Terminal
Block
UL-Listed
Strain Relief
UL-Listed
4-Wire
Power Cord
Remove the terminal block access cover
on the upper back of the dryer. Install a
UL-listed strain relief into the power cord
through-hole; then thread the power cable
prepared in Step 1 through the strain relief.
20
f Hot : N__ -_ ....
...............................(Black) (White) (Red)
Ground Screw _
.......... -r2uu . ...
Transfer the dryer's ground wire from behind
the green ground screw to the center screw
of the terminal block. Attach the two hot
leads of the power cable to the outer terminal
block screws. Attach the white neutral wire
to the center terminal block screw. Attach the
power cable ground wire to the green ground
screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
3828EL3003V en.indd 20 2009.7.14 3:18:11 PM