Beurer TL 35 Instrucciones De Uso página 19

4. WARNINGS AND SAFETY NOTES
 WARNING
• The daylight therapy lamp is only intended for the use on the human body.
• Before use, ensure that all packaging materials are removed and that there is no visible damage to the
device or accessories. When in doubt, do not use the device and contact your retailer or the specified
Customer Service address.
• This equipment is not intended for use by children and persons with reduced physical, sensory and
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the equipment to ensure that they do not play with the equipment and to
avoid the risk of fire and burns.
• Ensure that the daylight therapy lamp has a firm footing.
• Connect the device only to the mains voltage listed on the type plate.
• Check if the voltage indicated on the equipment corresponds to the local mains voltage before you
connect the equipment to avoid risk of electrocution or permanent damage to the equipment.
• Do not dip the device into water and do not use it in wet rooms.
• Keep children away from packaging materials (risk of suffocation!).
• Do not cover up or pack away the device while it is warm.
• Always unplug the mains adapter and allow the device to cool down before touching it.
• Always unplug the appliance after use and in case of a power failure to avoid risk of damage to the
equipment.
• Do not touch the device with wet hands while it is plugged in and do not allow any water to be sprayed
onto the device. The device must be operated only when it is completely dry.
• Ensure that you only insert and remove the mains adapter with dry hands and that you only press the
ON/OFF button with dry hands.
• Keep the mains cable away from hot objects and naked flames.
• Protect the device from strong impacts.
• Do not pull the mains adapter out of the socket using the mains cable.
• Do not use the device if it shows signs of damage or does not function properly. In these cases, contact
Customer Services.
• If the mains connection cable of this device is damaged, it must be disposed of. If it cannot be removed,
the device must be disposed of.
• Disconnection from the power supply network is only guaranteed when the mains adapter is unplugged.
• Do not use the device in the presence of flammable anaesthetic gas connections with air, oxygen or
nitrogen oxide.
• Do not leave the device unattended when it is switched on to avoid the risk of fire or burns.
• If the wall socket used to power the device has poor connections, the plug of the device becomes hot.
Make sure you plug the device into a properly installed wall socket to avoid the risk of fire and burns.
• Do not subject the device to heavy shocks to avoid risk of damage to the lamp.
• Water and electricity are a dangerous combination! To avoid risk of electrocution:
- Do not use this equipment in wet surroundings (e.g. in the bathroom or near a shower or swimming
pool);
- Do not let water run into the appliance.
• No calibration and no preventive checks or maintenance need to be carried out on this device.
• You cannot repair the device. The device contains no parts that you can repair.
• Do not make any changes to the device without the manufacturer's permission.
• If the device has been changed, thorough tests and checks must be carried out to ensure the continued
safety of the device for any future use.
• To avoid strangulation and entanglement, keep cable out of reach of young children.
• The patient is an intended operator. The patient can use the device and its accessories according to
this manual.
19