Tena SmartCare Change Indicator Instrucciones De Uso página 24

en
TRANSMITTER LIGHTS & BUTTONS
Battery installation
Once the battery has been installed in the
transmitter:
LED LIGHT WHAT IT MEANS
Blinks five times:
The battery is in the correct
position. Attach the transmitter
to the sensor strip.
No light: OK
The light disappears after
a few seconds. Check for power
by pressing both buttons
simultaneously for two seconds.
Applying the Change Indicator to the incontinence product
Press both buttons simultaneously for two seconds at every change of incontinence product
to register the change in the app.
LED LIGHT WHAT IT MEANS
Steady light for a few seconds:
Everything is OK.
Blinks five times:
The transmitter is not attached
properly or the battery is low.
Try re-attaching the transmitter.
If it does not help, change
the battery.
No light:
Error. See pp. 25–29 for more
information.
Buttons
LED light
Change Indicator assembly
Once the transmitter has been attached to
the sensor strip:
24
TENA SmartCare Change Indicator
NOTE
The LED light can be difficult to
see if exposed to a strong sunlight,
for example. Try to block the
sunlight to improve readability.
LED LIGHT WHAT IT MEANS
Steady light for a few seconds:
Everything is OK.
Blinks five times:
The transmitter is not attached
properly or the battery is low.
Try re-attaching the transmitter.
If it does not help, change
the battery.
No light: OK
The light disappears after
a few seconds. Check for power
by pressing both buttons
simultaneously for two seconds.
TM/MC