Publicidad
Idiomas disponibles
Idiomas disponibles
Auto Shut Off
The dehumidifier shuts off when the bucket is full, or when the bucket is removed or not replaced in theproper position.
For some models, the fan motor will continue to run for 30 seconds.
Wait 3 minutes before resuming operation After the unit has stopped, it can not be restart operation in the first 3
minutes.This is to protect the unit. Operation will automatically start after 3 minutes.
Check filter feature
The system starts to count the time once the fan motor operates. The check filter feature can be only activated when the accumulated
operation time achieves 250 hours or more. The Reset light(Clean filter indicator light) flashes at one time per second, after finishing
clean the air filter, press the Filter button and the Reset light(Clean filter indicator light) goes off.
Auto-Restart
If the unit breaks off unexpectedly due to the power cut, it will restart with the previous function setting automatically when the power resumes.
Setting the Timer
When the unit is on, first press the Timer button, the Timer Off indicator light illuminates. It indicates the Auto Stop program is initiated. Press it
again the Timer On indicator light illuminates. It indicates the Auto Start is initiated.
When the unit is off, first press the Timer button, theTimer On indicator light illuminates. It indicates the Auto Start program is initiated. Press it
again the
Timer Off indicator light illuminates. It indicates the Auto Stop is initiated.
Press or hold the UP or DOWN button to change the Auto time by 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours.
The control will count down the time remaining until start.
The selected time will register in 5 seconds and the system will automatically revert back to display the previous humidity setting.
When the Auto Start & Auto Stop times are set, within the same program sequence, Timer On Off indicator lights illuminate identifying both On
and Off times are now programmed.
Turning the unit On or Off at any time or adjusting the timer setting to 0.0 will cancel the Auto Start/Stop function.
When LED display window displays the code of P2, the Auto Start/Stop function will also be cancelled.
Electronic Work
DISPLAY
POWER
MAIN
SUPPLY
CONTROL
CORD
NOTE: The cographs are for
explanation purpose only. Your
machine may be slightly different.
The actual shape shall prevail.
WARNING:
BEFORE PERFORMING ANY ELECTRICAL OR WIRING
WORK, TURN OFF THE MAIN POWER TO THE SYSTEM.
13
Publicidad
