Donner ARENA2000 Instrucciones De Uso página 15

SPECIFICATION
Sample Rate: 44.1kHz
AD/DA: 24bits
Presets: 150
Loop: 60Sec
Display: 3.5"TFT 320x480
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits setforth for an uncontrolled environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
IC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The term "IC: " before the certification/registration number only signifies that the Industry Canada technical specifications were met.
This product meets the applicable Industry Canada technical specifications.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum
distance of 20centimeters between the radiator and your body.
Input Level：1.85V
Input Impedance: 470KΩ
Unbalanced Output Level: 2.6V
Unbalanced Output Impedance: 100Ω
Phone Output Level: 1.2V
Phone Output Impedance: 10Ω
Balance Output Level: 2.4V
Balance Output Impedance: 200Ω
AUX Input Level: 2.3V
12
AUX Input Impedance: 10KΩ
Power: 9V Negative Tip 500mA
Dimensions: 292.5mm x 147.2mm x 50.9mm
Weight: 1.32kg