MIRKA 1230 M Instrucciones De Manejo página 87

CAUTION
If the motor cooling filter is clogged by dust the overload protection switch in the motor may be tripped . If this
happens, switch off the machine, clean the motor cooling filter and allow machine to cool for approx . 5 minutes .
3.7 Wet pick-up
CAUTION
The machine is equipped with a water level limit system which shuts off the machine when the maximum liquid level is
reached . When this occurs, switch off the machine . Disconnect the machine from the socket and empty the container .
Never pick up liquids without the water level limit system and filter in place .
Picking up liquids
• Do not pick up flammable liquids .
• Before liquids are picked up, always remove the filter bag/disposal bag and check that the water level limit works
properly .
• If foam appears, stop work immediately and empty the container .
• Clean the water level limiting device regularly and check for signs of damage .
Before emptying the container, unplug the machine . Disconnect the hose from the inlet by pulling out the hose . Release
the container clamps by pulling them outwards so that the motor top is released . Lift the motor top off the container .
Always empty and clean the container and water level limit system after picking up liquids .
Empty by tilting the container backwards or sideways and pour the liquid into a floor drain or similar . Refit the motor
top on the container . Secure the motor top with the container clamps . Sudden movements can accidentally trigger
the water level limiting device . Should this happen; turn off the machine and wait for 3 seconds to reset the device .
Continue to operate the machine afterwards .
3.8 Dry pick-up
CAUTION
Picking up environmentally hazardous materials . Materials picked up can present a hazard to the environment .
• Dispose of the dirt in accordance with legal regulations .
Unplug the machine before emptying after dry pick-up . Release the container clamps by pulling them outwards so that
the motor top is released . Lift the motor top off the container .
Main filter: Check the filter . To clean the filter you can brush or wash it . Wait until the filter is dry before re-starting dust
pick-up .
Dust bag: Check bag to ensure the fill factor . Replace dust bag if necessary . Remove the old bag . The new bag is fitted
by passing the cardboard piece with the rubber membrane through the vacuum inlet . Make sure that the rubber
membrane passes the raised part of the vacuum inlet .
After emptying: Close motor top on the container and secure the motor top with the container clamps . Never pick up
dry material without having a filter fitted in the machine . The suction efficiency of the machine depends on the size and
quality of the filter and dust bag . You should therefore only use an original filter and dust bags .
4. After using the machine
4.1 After use
Unplug the machine from the socket when the machine is not in use . Wind up the cord starting from the machine . The
power cord can be wound up around the motor top or the container, or hung from the hook provided, or some other
fastener .
Mirka® Dust Extractor • 1230 M & 1242 M • 230 V / 100–120 V • PC & AFC
en
87