Descargar Imprimir esta página

BRC 09SQ4SDIP080GH Instrucciones página 8

Publicidad

2.0
Fuse
Fuse
5A
15A
Relé
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
LPG SEQUENT DIRECT INJECTION 2.0
Audi Q5 2.0i 16V TFSI (CDN) 155 kW Euro 5
Multipoint Electronic Injection
Changeover
Switch
Cut and
Insulate
Gas Pressure
1
2
3
and
Temperature
Sensor
Gas
Inlet
Gas Injectors Sequence
Wiring diagram
Diagnostic
Point
3
2
1
Cut and
Insulate
Pin 67 conn. 94 Pin (CAN L - OBD)
Pin 68 conn. 94 Pin (CAN H - OBD)
Pin n° 33 Conn. 60 PIN (1° Injector Signal)
Pin n° 31 Conn. 60 PIN (1° Injector POositive)
Pin n° 49 Conn. 60 PIN (2° Injector Signal)
Pin n° 47 Conn. 60 PIN (2° Injector POositive)
Pin n° 34 Conn. 60 PIN (3° Injector Signal)
Pin n° 32 Conn. 60 PIN (3° Injector POositive
Pin n° 48 Conn. 60 PIN (4° Injector Signal)
Pin n° 46 Conn. PIN (4° Injector POositive)
Water temperature
DO NOT CONNECT
4
Petrol
Injectors
Sequence
8|8
Level sensor connector
Red
Cut and Insulate
Rear Solenoid Valve Connector
Black
Black
Black
Red
Red
+
-
Battery
Pin 87 conn. 94 Pin
Pin n° 54 conn. 60 Pin
Pin 40 conn. 60 Pin
MAP
Sensor
Date:
28_07_17
Diagram n°
4
In place of dg n°
21_12_15
Draftsman:
I.C.
Signature:
fusibili
Petrol
ECU
MV
FSG000028R-2

Publicidad

loading