Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND CONFIGURATION
DEVICE ATTACHMENT
Optionally, the device can be fixed by using the assembly holes (2). Distance between holes: 154 mm.
MOUNTING
To install the WFI Repeater module in any NEXU device
that has CAN BUS, the following procedure will be
followed:
1. Connect to the CAN BUS connector (branch) of the
WIFI Repeater, a NEXU device with power. This channel
is the one that provides power to the WIFI Repeater.
EQUIPMENT CONFIGURATION
WIFI Module connection with a Wifi network
In order to configure the device remotely (Mode 1 or 2) it
will be necessary to connect to it through the WIFI
network that it generates.
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
NOTE: For the correct operation of the device, it is
therefore essential, to connect the power supply to the
CAN BUS connector (branch).
2. In the other two CAN BUS connectors (trunks) of the
WIFI repeater, NEXU devices can be connected, without
the need to include power for the supply.
The SSID of your local network is "UPOWER-X" where X
will be the local address of the device and it could be
changed locally through its configuration. The password
to access this network is "123456789".
EN
3
R. 05/23 105 294
Publicidad
