Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING MODE
START
When you turn on the module, it will automatically start
the boot process:
1. NEX·U· logo is displayed
2. The firmware version loaded on the device is displayed
3. The WIFI setup process begins. This process tries to
connect to the network that has been configured. (In
case of being the first time, there will be no network
configured).
4. If the WIFI setup network has been correct, WiFi logo
will be displayed. Otherwise, it will appear a logo
signaling that there isn't a network available.
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
EN
5
R. 05/23 105 294
Publicidad
