Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING MODE
PROCESS
First, we can change the local address of the device
1
using the UP and DOWN buttons.
You can scroll through the different digits using
3
RIGHT/LEFT buttons, and scroll through each digit
from 0-9 using UP/DOWN buttons. Once the correct
IP has been set, press ENTER.
At this point, the device will automatically search for
available networks and display their SSIDs, so that
you can use the UP/DOWN buttons to select the
correct SSID and confirm by pressing ENTER again.
The same to the UNET IP, you can scroll through the
5
different digits using RIGHT/LEFT buttons, and scroll
through the different symbols/ letters/ascii digits
using UP/DOWN buttons
To confirm the password press ENTER.
At this time, the device will begin to connect to the
selected NETWORK.
If the whole process is successful, the assigned IP
address will be displated in the first line, along with
the Gateway and subnet mask.
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
To move on to the next item, press the ENTER
2
button. Next you will go through the process of
setting up the WIFI connection. The first point will be
to set the IP address of the UNET.
Then, you have to enter the corresponding
4
PASSWORD for the SSID selected.
Finally, a setup OK message will be displayed, before
6
the device reboots.
NOTE: In case any error occurs during the WIFI
network connection process, an ERROR message will
be displayed. From version 1.02 onwards, if the
ERROR is due to an incorrect SSID or PASSWORD it
will be specifically indicated.
EN
7
R. 05/23 105 294
Publicidad
