Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
NOTE: The V20 is a dual voltage motor that can be converted between 115VAC
and 230VAC if needed. For the motor to run in 115V configuration, couple the
blue and orange motor leads together with a wire nut and then couple the white
and yellow motor leads together along with the yellow lead from the switch with
another wire nut. For the motor to run in 230V configuration, insulate the blue
motor lead with a small wire nut, couple the orange and white motor lead with a
wire nut and couple the yellow motor lead with the yellow lead from the switch
with another wire nut. Refer to the wiring diagram.
171902-01
3.
Match voltage, connect motor to power supply phases. (see Figures 7a/7b)
4.
Position wires inside the junction box and replace electrical cover. Install all
four (4) screws.
14
EN
NON-PX
WIRING DIAGRAM
WIRING DIAGRAM
BROWN
171902-02
PX
BROWN
Figure 7a
Rev (-)
Figure 7b
Rev (-)
Publicidad
