Waterpik Water Flosser WF-10 Manual De Instrucciones página 6

6
GETTING STARTED
Charging Unit Prior to First Use
If the charger is not included with your unit, a user supplied USB-Charger with a Type-A USB connector that is rated for 5 VDC @ 1A
is required to charge the unit. Plug the USB-charger into a wall outlet and connect the magnetic charger cord to the unit. Ensure
contacts on BOTH the cord and unit are clean and dry before connecting the charger. The LED light will display a single, rapid
blink every 3 seconds when unit is fully charged and the charger is connected. A full charge will last for approximately 1 week of typical
use. When the batteries are in need of charging (approximately 30% charge lef) the charge indicator light will blink 8 times quickly afer
use to indicate that you should recharge the unit. A complete recharge will take 3-4 hours. If you use your Water Flosser once a day or
less, it is recommended you charge it once a week. If you use it twice a day or more, charge the unit more frequently.
Fill
Filling the Reservoir
Remove the magnetic charger from the unit prior to flling reservoir and product use. Lif fip top on reservoir and fll the reservoir with
lukewarm water.
Eject
Inserting and Removing Tips
Insert
Insert tip into the center of the knob at the top of the Water Flosser handle. Press frmly until the tip clicks into place. To remove the tip
from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.