Waterpik Water Flosser WF-10 Manual De Instrucciones página 7

Pressure
Setting
Remove
Adjusting the Pressure Setting
First press power button. Unit will start on "low."
Press power button a second time, this will turn unit to "high."
Pressing button third time will turn unit "of."
The single LED exhibits the following behavior:
• Solid - If motor is running and battery is greater than half full.
• Single, rapid blink every 3 seconds when unit is fully charged and the charger is connected.
Recommended Technique
Lean low over sink and place tip in mouth. Aim the tip toward gumline, and turn the unit ON.
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefy between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to fow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit of. Empty any liquid lef in the reservoir.
If desired, the reservoir may be removed from the power handle by simply pulling down on the reservoir to remove.
7