GE Profile Serie Manual Del Propietário página 14

Loading
A loaded upper rack may be
CAUTION
heavier than anticipated. To prevent
minor injury or damage to the contents, do not raise
or lower the upper rack after the rack is loaded.
The upper rack allows 2" of adjustment up or down to
accommodate large items. The upper rack may be lowered
by pushing the long flaps on each side of the rack. This will
allow you to lower the rack (see fig. Upper Rack). To raise
the rack, lift up on the rack until the rack locks in place.
On some models, the upper rack may be adjusted to
accommodate larger items. To adjust the upper rack, fully
extend the upper rack and remove the two plastic end caps
on the front of the rails. Remove the upper rack. Select
the set of rollers on the side of the rack that provides the
desired height, and reinstall the upper rack by guiding the
rack rails between the appropriate set of rollers. With the
rack reinstalled, replace the two plastic end caps, ensuring
the snap is properly engaged. Failure to properly engage the
end caps may result in the rack falling from the dishwasher.
To add flexibility in loading, the stem safe shelf (on some
models) may be placed in the up or down position or
unfolded and placed in the lower unfolded position.
The shelf may also be used to secure stemware such as
wine glasses. Because these stemware items come in
various sizes, slowly push the rack in to ensure the items
do not bump into the edges of the dishwasher, which
may cause damage to the items.
The fold down tines (on some models) provide flexibility
for extra-large and hard-to-fit items. The tine rows can be
adjusted to a vertical or lay-down position.
For best dishwashing results, follow these loading guidelines. Features and appearance of racks and silverware
baskets may vary from your model.
8 Place Settings - Upper Rack
Models - GDF570, GDF650, GDT655, PDF820,
PDT825, PDT845 & CDT835
14
Upper Rack
End
Cap
Place the
slots in the
utility shelf
clips over
the vertical
rack wires
and push
down to attach
utility shelf
onto second
wire of rack
Models - DDT595, GDT695, PDT855 & CDT865
Rail
Rollers
49-55119-2