EGO POWER+ SNT2100-FC Manual Del Operador página 21

The throwing distance of the snow
blower is adjusted by moving the chute
deflector up or down (Fig. 19). Release
the bail switch before adjusting the chute
deflector.
1. To increase the distance that the
snow is thrown, squeeze the trigger
on the chute-deflector handle,
and then raise the chute deflector.
Release the trigger on the chute-
deflector handle to lock the chute deflector in place (Fig.19).
2. To decrease the distance that the snow is thrown, simply lower the deflector with
the chute-deflector handle.
WARNING:
the deflector and the chute itself. Snow or other debris could be thrown through the
gap and back at the operator, resulting in serious personal injury.
WARNING:
Always release the bail switch before adjusting the chute deflector.
CLEARING A CLOGGING CHUTE
WARNING:
the most common cause of injury associated with snow blowers. Never use your hand
to clean out the chute.
To Clear the Chute:
1. Shut the motor and auger off!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use a clean-out tool, such as a wood rod or other clearing tools that are
commercially available; do not use your hand.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100/SNT2100-FC
Do not force the chute so far forward that a gap appears between
Do not adjust the chute deflector while the bail switch is engaged.
Hands coming in contact with the rotating auger inside the chute is
19
Trigger
Chute
Deflector
21