Publicidad
3
CRIB ASSEMBLY - MATTRESS SUPPORT PANEL ASSEMBLY
3a. Align the Mattress Support Panel (6) to all the corners of the crib as
shown in the illustration.
3b. Position the Wooden Dowels (D) in the center insertions between
the mattress support panel and conversion rail.
3c. Use the Bolt (C) to attach the Mattress Support Panel to the corners
of the crib.
3d. Note that the Lowest position of the
Mattress Support Panel will be for
Toddlers (babies who can stand up
and walk), the Mid position is for
infants (babies who start to turn and
sit up) and the Highest Position is
for newborn babies.
3e. Ensure that the Mattress Support
Panel is flat side up and not at a
slant.
NOTE:
• The Warnings printed on the pouch
attached to the mattress support
panel must face up, and the springs
must face up.
• This crib has adjustment positions. Use
the highest only for newborns, and move
the mattress down as the child grows.
WARNING:
Fall Hazard: When a child can stand, set the
mattress at the lowest position and remove
bumper pads, large toys, and other items
that could serve as steps for climbing out.
C
Bolt M6 X 15mm (x4)
Boulon M6 X 15mm (x4)
Perno M6 X 15mm (x4)
18
D
Wooden Dowel (×2)
Cheville en bois (×2)
Clavija de madera (×2)
(C)
(D)
(C)
(C)
6
(D)
6
By
Publicidad
