GE 18 Serie Manual Del Propietario E Instalación página 6

About the shelves and bins.
Not all features are on all models.
Rearranging the Shelves
Shelves in the refi'igerator and fi'eezer compartments are a(!iustable.
Refrigerator Compartment
To remove:
0 Tilt the shelf up at the fl'ont.
@ I,ifl the shelf up at the back and bring
the shelf out.
Some models have wire shelves that
can be adjusted in the same mam?er.
e-_
[¸/¸¸¸¸7¸7¸¸¸
To replace:
0
_ hile tiltino_ the shelf u _, insert the tel _
hook at theback of thelsheff in a slot
on the track.
I,ower the fl'ont of the shelf tmfil the
bottom of the shelf locks into place.
Freezer Compartment
Toremove:
i,ifl up the left side of the shelf and
slide it left into the center of the shelf
suI)ports.
@ Rotate the right, side of the shelf up and
out of the shelf supports.
To replace:
Holding the shelf diagonally, insert the
left end of the shelf into the center of
the lower shelf sui)ports on the side
wall.
@ Insert the right end of the shelf into the
shelf supports at the same lexel. Rest
each end of the shelf on the bottom of
the shelf supports.
"llValldng" the shelf
In some models, moving the shelf between
the lower and upper position may require
"walking" the shelf as shown. I,iJt up the left
side of the shelf and slide it leli into the
center of the shelf supports. Then swing the
right side upwards and insert it into the
NOTE:Formodelswith an automaticicemaker,
the freezershelf mustbe in the lowerposition for
the icecubebucketto catchthe cubes.
center (ff the upper shelf supports. Slide the
left side out of the shelf supports, swing it
upwards tmtil level with the right side and
slide it into the shelf sui)ports. Rest each
end of the shelf on the bottom of the shelf
suI)ports.
i n
6
Spillproof Shelves (on some models)
Spillproof shelves have special edges to
hel I) prevent spills fl'om dripping to lower
shelves. To remove
or replace
the shelves,
see Rearranging the Shelves.