GE 18 Serie Manual Del Propietario E Instalación página 7

ge.com
I i i
I i i i i
ii i I i i
Front bar
Slide-Out Spillproof Sheff (on some models)
The slide-out spillproof shelf alhms you
to reach items stored behind othe_s. The
special edges are designed to hel I) prexent
spills from dripping to lower shelxes.
NOTE: The shelves are shipped with tape on
the hack. Remove this tape before attempting
to remove the shelf.
Toremove:
0 Remove all items ti'om shelf.
0 Slide the shelf out until it stops.
i,ifl the ti'ont edge of the shelf until the
tabs are above the shelf ti'ame.
0 Continue pulling the shelf fi)rward until
it can be lifted out and removed.
Toreplace:
0 Place the rear of the shelf on the shelf
fl'amejust behind the fl'ont ba_;
@ Slide the shelf back until the tabs are
aboxe the oi_enings, .
I,ower the shelf so that the tabs go into
the oi)enings;, then slide the shelf all the
WaY in.
Makesurethattheshelfsits flat afterrelbsta//at/on
and doesn't m ovefreelyfromsideto side.
Makesureyoupushtheshelves aft theway in
beforeyoudosethedoor
Fingerhdd
,Snugger
Adjustable Bins on the Door (onsome models)
A(!justable bins can easily be carried fl'om
refl'igerator to work area.
Toremove: i,ifi bin straight
up; then pull out.
To replace or relocate: Engage the bin in the
molded SUl)ports of the door and push
down. Bin will lock in place.
The snugger (on some models) helps prevent
tipping, spilling or sliding of small items
stored on the door shelf, Grip the finger
hold near the rear of the snugger and move
it to fit your needs.
NOTE." Binsfor therefrigerator and freezer
doorsare different sizesand are not
interchangeable.
\ Non-Adjustable Shelves on the Door
Detachable shelves deepen and enclose
fixed door shelves, providing more storage
room and greater storage flexibilit,i.
To remove: lift the shelf straight
up; then
pull out.
To replace: Engage the shelf extender in
the molded sui_ports on the door and push
down. It will lock in place.
Freezer Tilt-Out Bin (onsomemodels)
Push the button as _ou flit out the bin.
Toremove: Hold the sides of the bin and
lift it straight tip; then pull out.
Toreplace: Engage
the ends of the bin
in the molded sui)ports on the door and
push down. It will lock in place.
NOTE:Do not overloadthe bin.