Troubleshooting; Disposal - Dometic COOLFREEZE CDF 11 Instrucciones De Uso

Troubleshooting

8 Troubleshooting
Fault
Device does not function,
"POWER" LED does not
glow.
The device does not cool
(plug is inserted, "POWER"
LED is lit).
The device does not cool
(plug is inserted, "POWER"
LED flashes, the display is
blank).
When operating from the
12/24 V socket (cigarette
lighter):
The ignition is on and the
device is not working and
the "POWER" LED is not lit.
Pull the plug out of the
socket and make the
following checks.
"ERROR" LED flashes and
the display shows "ERR1"
or "ERR2".
9

Disposal

➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
18
Possible cause
There is no voltage
present in the
12/24 V socket
(cigarette lighter) in
your vehicle.
Defective
compressor.
The voltage present
in the 12/24 V socket
is too low.
The cigarette lighter
socket is dirty. This
results in a poor
electrical contact.
The fuse of the
12/24 V plug has
blown.
The vehicle fuse has
blown.
Device is defective.
CoolFreeze CDF11
Suggested remedy
The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
This can only be repaired by an
authorised customer repair agent.
Check the battery and charge if
necessary.
Check the wiring and connections.
If the plug of your cooler becomes
very warm in the cigarette lighter
socket, either the lighter socket must
be cleaned or the plug has not been
assembled correctly.
Replace the fuse (5 A) in the cigarette
lighter plug, see chapter "Replacing
the plug fuse (12/24 V)" on page 17.
Replace the vehicle's 12/24 V socket
fuse (usually 15 A). Please refer to your
vehicle's operating manual.
This can only be repaired by an
authorised customer repair agent.
EN