MTD Yard-Man YMGBV3100 Manual Del Operador página 18

CARBURETOR ADJUSTMENT
The idle speed of the engine is adjustable through the air
filter/muffler cover (Fig. 29).
NOTE: Careless adjustments can seriously damage your
unit. An authorized service dealer should make
carburetor adjustments.
Check Fuel Mixture
Old and/or improperly mixed fuel is usually the reason
for improper unit performance. Drain and refill the tank
with fresh, properly-mixed fuel prior to making any
adjustments. Refer to Oil and Fuel Information.
Clean Air Filter
The condition of the air filter is important to the operation
of the unit. A dirty air filter will restrict air flow and
change the air/fuel mixture. This is often mistaken for an
out of adjustment carburetor. Check the condition of the
air filter before adjusting the idle speed screw. Refer to
Air Filter Maintenance.
Adjust Idle Speed Screw
If not and all of the following are true:
, the engine will not idle
, the engine hesitates or stalls on acceleration
, there is a loss of engine power
Have the carburetor adjusted by an authorized service dealer.
Idle Speed
Screw
WARNING: This unit will need
to be running during
idle speed adjustment. Wear protective
clothing and observe all safety instructions
to prevent serious personal injury.
Also, DO NOT set unit on any surface
except a clean, hard area while starting or
performing any adjustments. Debris such
as gravel, sand, dust, grass, etc. could be
picked up by the air intake and thrown out
by the discharge opening, damaging unit,
property, or causing serious injury to
bystanders or operator.
If after checking the fuel mixture and cleaning the air
filter the engine still will not idle, adjust the idle speed
adjuster as follows.
1. Start the engine and let it run at the fast position for a
minute to warm up.
2. Set the blower/vacuum mode change-over lever to
the up position (Blower Mode). Refer to Operating as
a Blower.
NOTE: Setting the lever to the blower mode prevents the
vacuum bag from filling up while starting or
running the unit.
3. Move the throttle control and let the engine idle. If the
engine stops, insert a small phillips screwdriver into
the hole in the air filter/muffler cover (Fig. 29). Turn
the idle speed adjuster in, clockwise, 1/8 of a turn at
a time (as needed) until the engine idles smoothly.
4. If the unit appears to be idling too fast, turn the idle
speed adjuster counterclockwise 1/8 of a turn at a
time (as needed), to reduce idle speed.
Checking the fuel mixture, cleaning the air filter, and
adjusting the idle speed should solve most engine
problems.
Fig. 29
REPLACING THE SPARK PLUG
Use a Champion RDJ7Y spark plug, or equivalent. The
correct air gap is 0.020 inch (0.5 ram). Remove the plug
after every 25 hours of operation and check its condition.
1. Stop the engine and allow it to cool. Grasp the plug
wire firmly and pull it from the spark plug.
2. Clean around the spark plug. Remove the spark plug
from the cylinder head by turning a 5/8-inch socket
counterclockwise.
3. Replace a cracked, fouled or dirty spark plug. Set
the air gap at 0.020 in. (0.5 ram) using a feeler gauge
(Fig. 30).
WARNING:
Do not sand blast,
scrape or clean
electrodes. Gritinthe engine could damage
the cylinder.
4. Install a correctly-gapped spark plug in the cylinder
head. Tighten by turning the 5/8-inch socket
clockwise until snug.
If using a torque wrench torque to:
110-120 in.. lb. (12.3-13.5 N.m)
Do not over tighten.
0.020 in.
(0.S ram)
1
Fig. 30
18