Descargar Imprimir esta página

LEGRAND C2G C2G31017 Manual Del Usuario página 4

Hdmi hdbaset + vga, 3.5mm, rs232, e ir sobre cat extensor transmisor de placa de pared de doble gang - 4k 60hz

Publicidad

Idiomas disponibles

Idiomas disponibles

HDMI HDBaseT + VGA , 3.5mm, RS232, and IR over Cat Extender Dual Gang
Wall Plate Transmitter - 4K 60Hz
Product Overview
Front Panel
F
P
D
RONT
ANEL
ESCRIPTION
1
VGA IN
VGA input. Connect to a VGA source.
2
VGA AUDIO
Audio input embedded with VGA input.
3
HDMI IN
HDMI input. Connect to an HDMI source.
4
UPDATE
Micro USB port. Connect to a PC for firmware upgrade.
5
Input Selection LEDs
LED On: Corresponding input channel is selected.
On: HDCP protected content is being transmitted.
6
HDCP LED
Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
7
LINK LED
Off/Blinking: No HDBT link or link error.
Transmitter
Rear Panel
8
SELECT
Input selection button.
9
IR SENSOR
Receives IR signal from IR remote.
EDID Switch for VGA EDID management. For more
10
EDID
information, see EDID Management section.
R
P
D
EAR
ANEL
11
HDBT OUT
HDBaseT Output. Connect to an HDBaseT receiver.
12
Power IN
For local DC 12V input.
For DC 12V output when the "Power In" port is connected
13
Power OUT
to local power supply. If the transmitter is powered by
PoC, this port doesn't output power.
14
RS232
For RS232 pass-through.
IR signal output. Connect to an IR emitter using the 2-pin
15
IR OUT
phoenix connector provided.
2
Transmitter
⑬ ⑭ ⑮
ESCRIPTION
(us)
(us)

Publicidad

loading