LEGRAND C2G C2G31017 Manual Del Usuario página 6

HDMI HDBaseT + VGA , 3.5mm, RS232, and IR over Cat Extender Dual Gang
Wall Plate Transmitter - 4K 60Hz
Cable Installation
Warnings:
Before wiring, disconnect the power from the device.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect HDBT: Connect HDBT OUT of the transmitter to
HDBT IN of an HDBT receiver via a Cat 5e/6/6a/7 cable.
2. Connect an HDMI display to the receiver.
3. Connect power adapter to the receiver.
4. Connect a power adapter to the transmitter (If the receiver
includes PSE module, it can send power to the transmitter
and no additional power adapter is required at transmitter
side).
5. Connect the video sources to the transmitter.
6. Power on all attached devices.
7. Select a desired video source through automatic or manual
switching function.
4
(us) (us)
(us)