HTW -SIF20120BN Manual De Usuario página 7

In order to use this fan well, please read these instructions carefully before using it for the first time.
We also recommend that you keep the instructions for future reference, so that you can remind
yourself of the functions of the fan.
Overview of functions:
Setting up the fan
- Remove the wing screw from the motor housing
- Fit the rear grill onto the motor pain. Make sure that the 2 holes on the motor match the 2 holes on the
rear grill, and then fit the wing screw and screw it on firmly
- Put the blade on the motor shaft and carefully tighten the screw
- Fit the front grill onto the rear grill and fix them together using the metal clips. Tighten the small
screw
- Fix the standing pipe on the base, tighten the base with the heavy base by the base nut and base
screw
- Put the motor housing, which had been fixed by the front grill, blade and rear grill on the top of stand
pipe
Important safety measures
Please ensure that the voltage of the fan corresponds to the mains voltage.
- Use the fan only for the purpose(s) defined in the user guide.
- Never insert your fingers, pencils or other objects through the fan cage during operation.
- Switch the fan off before moving or cleaning.
- The fan should be set up on a stable and level surface to avoid it being knocked over.
- Do not expose the fan to excessive heat or humidity, as this can cause damage to the electrical
components.
- Do not immerse in any form of liquid.
- It is not advisable to expose people, in particular babies and the elderly, to a continuous stream of
cold air.
- The fan should be kept out of reach of children.
1 FRONT GRILL
2 BLADE
3 BLADE SCREW
4 WING SCREWS
5 REAR GRILL
6 MOTOR SHAFT
7 MOTOR HOUSING
SPEED CONTROL&
8
OSCILLATION SWITCH
9 NECK
10 POWERCORD
11 STANDING PIPE
12 BASE
13
HEAVY BASE
14 BASE NUT
15 BASE SCREW