EN
2. Run water through the filter from a hose or spigot.
Check the cartridge filter for tears or small holes after
cleaning. Do not use a cartridge filter with holes or
tears in it. Even a small hole can allow dust to come
out of your machine. Replace it immediately.
10.2 CLEAN THE MACHINE
To keep your machine looking its best, clean the outside
with a cloth dampened with warm water and mild soap.
To clean the collection tank:
•
Properly discard of any debris in the collection tank
•
Wash collection tank with warm water and mild
soap.
•
You can use a small brush to clean the dust and
debris.
•
Wipe out with dry cloth.
To disinfect the collection tank:
1. Pour 3,5 l of water and 1 teaspoon chlorine bleach
into the collection tank.
2. Let solution stand for 20 minutes, carefully swishing
every few minutes, making sure to wet all inside
surfaces of the collection tank.
3. Empty collection tank after 20 minutes. Rinse with
water until bleach smell is gone. Allow collection
tank to dry completely before sealing the motor on
the collection tank.
Disinfect the collection tank before storage or as
needed.
11
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
12
TROUBLESHOOTING
Problem
The machine
doesn't work.
NOTE
NOTE
NOTE
Possible cause
Solution
The switch or
Speak to service
motor is defec-
center.
tive.
English
Problem
Dust discharges
from exhaust.
Loss of suction
Static shock
13
TECHNICAL DATA
Voltage
Tanksize
Air Volume
Max suction
Weight (without battery
pack)
Hose
Accessory
Battery model
Charge model
The recommended ambient temperature range:
Item
Vacuum storage tempera-
ture range
Vacuum operation temper-
ature range
Battery charging tempera-
ture range
10
Possible cause
Solution
The filter has
Replace the fil-
damage.
ter.
The filter isn't in-
Properly reinstall
stalled.
the filter.
The filter is not
Clean or replace
functional.
the filter.
Clean or replace
The filter clogs.
the filter.
The hose con-
Tighten the hose
nection loose.
connection.
Clean or replace
The filter clogs.
the filter.
The collection
Empty the col-
tank is full.
lection tank.
The hose has
Replace the
damage.
hose.
Add moisture to
The environment
air (if practical,
is dry.
use a humidifi-
er).
40 V
3 gallons
75 CFM
14 kPa
11.46 lbs. (5.2 kg)
7-ft extenable hose
Crevice and utility tool
BAF705 and other BAF
series
29482 and other CAF ser-
ies
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)