Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Please do not operate the nail gun before loading the nails, as this may shorten
the service life of the nail gun.
Adjustable depth of drive Fig.2
Rotate the adjustment knob counterclockwise, at this time the bumper moves
toward the tip of the gun, and the nail will float out of the surface of the board;
Rotate the adjustment knob clockwise, at this time the bumper moves toward
the handle, and the nail will sink into the surface of the board.
Selectable drive-Choose either sequential or single fire mode
Switch to"T"—Single fire mode
Switch to"TTT"--Sequential fire mode
Dry fire defense Fig.3
When there is no nail in the magazine or the specified number of remaining nails,
the nail gun will not fire again to remind the operator to continue to put the nail
When only a few nails are left in the magazine, the machine stops firing nails. This
is a normal mechanism. It protects the work surface and warns the user that nails
must be loaded into the magazine.
Lighting Fig.4
When the tool is working, there is a light at the end of the motor of the tool that
can be illuminated to the nail opening.
Removing jammed staples Fig.5
First press the handle of the tail of the clip to open the movable clip;
Then pull the quick release wrench down and open the gun cover;
Use a screwdriver or pliers to remove the jammed nails
Hook replacement Fig.6
The mounting positions of the hooks are respectively arranged on the left and
right casings. According to the different habits of the left and right hands, a hook
screw is used to fix the hooks to the casing through the hook platen.
Safety cover Fig.3
When the working surface needs protection, install the sheath on the bumper
and remove the sheath from the clip of the clip or put it in the toolbox when it is
not needed.
5. SERVICE & MAINTENANCE
The FISCHER DAREX machines have been designed to operate over а long period
of time with а minimum of maintenance. Continuous satisfactory operation
depends upon proper machine care and regular cleaning.
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the
engine. Regularly clean the machine housing with а soft cloth, preferably after
each use. Keep the ventilation slots free from dust and dirt. 1f the dirt does not
Make sure that the machine is not live when carrying out maintenance
work on the motor.
62
Publicidad
