LUND AVS Ventvisor Instrucciones De Instalación página 2

Installation Steps
Align the deflector on the outside of the door frame. Insert the front flange BETWEEN the rubber window channel and the mirror cap. The
3
Gently press the exposed areas of tape against the surface and verify position. With the visor in its final position, remove the remaining
PRESS
visor
cross section of visor in
place
4
Apply pressure along all flanges to ensure proper adhesion of tape.
5
4 Piece Set
The rear visor attaches with the same preparation methods as the front visor. Insert a putty knife between the
vinyl roof and the rubber window channel. Then slide the rear end flange of the visor in behind the putty knife.
The lateral flange will attach to the chrome trim and the front flange will attach to the black plastic on the front
6
NOTE: Actual application may vary slightly from illustrations.
lateral flange of the visor will attach to the chrome trim.
mirror cap
tape liner by pulling on free ends.
window frame
rubber window channel
edge of the door.
Page 2 of 3
Visor in final position