HIKOKI C 3607DB Instrucciones De Manejo página 18

English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
Symptom
Tool doesn't run
Tool suddenly stopped
Cannot be inclined
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
Battery cannot be installed.
Possible cause
No remaining battery power
The trigger switch was held down
while the battery was inserted.
Battery isn't fully installed.
Tool was overburdened
Overload protection is in operation.
The battery is overheated.
The trigger switch was held down for
5 minutes or more.
The incline lever is not loosened.
The saw blade is worn or missing
teeth.
The bolt is loose.
The saw blade is installed
backwards.
The switch lock is not pushed in
enough.
Sawdust has accumulated in the saw
cover.
Attempting to install a battery other
than that specified for the tool.
18
Remedy
Charge the battery.
The safety function was activated.
If the trigger switch is released once
and then pulled again, the tool will
run.
Push the battery in until you hear a
click.
Get rid of the problem causing the
overburden.
Let the battery cool down.
This is not a malfunction.
The motor was automatically stopped
to prevent failure of the tool.
Try inclining after loosening the
incline lever.
Tighten the incline lever after making
the necessary adjustments.
Replace with a new saw blade.
Firmly tighten the bolt.
Install the saw blade in the proper
direction.
Push the switch lock in all the way.
Remove the sawdust inside the saw
cover.
Please install a multi volt type battery.