Publicidad
Idiomas disponibles
Idiomas disponibles
Switching the battery cartridge
Fig.18
► 1. Battery selection switch
The machine uses 2 battery cartridges for operation
at a time. Up to 4 battery cartridges can be installed
to the machine. Before operating the machine, select
the battery cartridges used for operation by turning the
battery selection switch.
NOTICE:
If the battery cartridge is in the follow-
ing condition, the machine does not work even if
you switch the battery with the battery selection
switch.
•
The remaining capacity of at least one of the
battery cartridges is empty.
•
At least one of the battery cartridges is
overheated.
In this case, remove the empty or overheated
battery cartridge, or replace the battery cartridge
with a charged one.
NOTE: If only 2 battery cartridges are installed to the
machine, be sure to select the installed battery car-
tridges with the battery selection switch.
1
17 ENGLISH
Control panel
CAUTION:
Always lock the brake lever and
turn off the machine when not in use.
Power button
1
2
Fig.19
► 1. Main power lamp 2. Power button
To turn on the machine, lock the brake lever, and then
press the power button without pulling the switch trig-
ger. The main power lamp lights up in green. To turn
off the machine, release the switch trigger and lock the
brake lever, and then press the power button.
NOTE: An electrical test is performed the first time
the machine is driven after the machine is turned on.
If a problem is detected, the main power lamp blinks
in red or green alternately. In this case, refer to the
section for troubleshooting.
NOTE: If the main power lamp lights up in red or
blinks in red or green, refer to the instructions for
machine/battery protection system or the section for
troubleshooting.
NOTE: This machine employs the auto power-off
function. To avoid unintentional start up, the machine
will automatically shut down when the machine is
stopped and not operated for a certain period after
the machine is turned on.
NOTE: If you press the power button while pulling the
switch trigger, the machine does not turn on. Release
the switch trigger, and then press the power button.
Publicidad
