Publicidad
Idiomas disponibles
Idiomas disponibles
ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Cycle Count Check Mode
Service Mode
Definition of Cycle Count Check Mode:
- Cycle Count Check Mode is to tally up the number of washings.
How to Enter:
Model : WF455AR*
- To enter the Cycle Count Check Mode, press the Signal Key during Service Mode.
Model : WF457AR*
- Press "2" on The Service Mode.
Cycle Count Check Mode:
1. Activate the Service Mode in advance.
2. When the Signal key is pressed, the total number of washings will light up and a signal LCD /
LED will glow.
3. The maximum number of cycles will be 9999.
The counter will roll over to 0 and start counting again after 9999.
4. The counting will be carried out at the end of the normal cycle.
(For normal and Continuous Run cycles, the count is carried out at the end of the cycles.
5. To exit the Cycle Count Check Mode, press the "Signal" key again.
S/W Version Check Mode
Definition of S/W Version Check Mode:
Service Mode
- S/W Version Check Mode is to bring up S/W Version information.
How to Enter:
Model : WF455AR*
- To enter the S/W Version Check Mode, press the Soil Level Key during Service Mode.
Model : WF457AR*
- Press "4" On the Service Mode.
S/W Version Check Mode:
1. Activate the Service Mode in advance.
2. Press the Soil Level Key to bring up its software Version
EX) Generate dE49 at Version 49 (dE is Micom code, 49 is it's software version)
3. To exit the S/W Version Check Mode, press the Soil Level S/W once again.
Then, it returns to the Service Mode with motor RPM illuminating.
(Techsheet)WF457AR-03152A_EN_20120404.indd 10
WARNING
WF455AR* : Signal
WF457AR* : 2 Key
WF455AR* : Soil Level
S/W Version Check
WF457AR* : 4 Key
10
Cycle Count
Mode
2012-04-04
12:12:28
Publicidad
