Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
To Start Your Pressure
Washer
To start your engine-powered
pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
•
Place the pressure washer in an area close
enough to an outside water source capable of
supplying water at a flow rate greater than
2.2 gallons per minute.
•
Check that the high pressure hose is tightly
connected to the spray gun and to the pump. See
"Assembling Your Pressure Washer" (page 6) for
illustrations.
•
Make sure unit is in a level position.
•
Connect the garden hose to the water inlet on the
pressure washer pump. Turn on the water.
,_
CAUTION: Do Not run the pump without the
water supply connected and turned on. You
must follow this caution or the pump will be
damaged.
•
Squeeze trigger on gun to purge pump system of
air and impurities.
•
Attach nozzle extension to spray gun. Tighten by
hand.
•
Position the nozzle in the low pressure mode (slide
nozzle forward) and squeeze the trigger on the
spray gun to relieve pressure caused by turning
ON the water. Water will flow out of the gun in a
thin stream. Continue to hold trigger until there is a
steady stream of water and no air remains in the
system. Release the trigger.
•
Engage the safety latch to the spray gun trigger.
_
Safety Latch
•
Move the choke lever to the "Closed" position.
NOTE: For a warm engine, be sure the choke lever is
in the "Open" position.
Choke
lever in
Open
position
Throttle
lever in
Fast
position
Move the throttle lever to the "Fast" position,
shown as a rabbit. Controls are shown in the
desired operating condition.
Rotate the fuel valve lever to the "On" position.
Place your left foot on the lower frame and grasp
the handle as shown. Unit appearance may differ
slightly. Pull the starter grip handle lightly with your
right hand until you feel some resistance, then pull
briskly. Return the starter grip handle slowly. Do
Not let rope "snap back" against starter.
If the unit fails to start, squeeze trigger to release
built up pressure. Repeat previous steps.
If the choke lever was placed in the "Closed"
position to start the engine, move it slowly to the
"Open" position as the engine warms up enough to
run smoothly.
How to Stop Your Pressure
Washer
•
Move throttle lever to "Stop" position.
•
Rotate the fuel valve lever to the "Off" position.
•
Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when
you release the pressure.
How To Use the Adjustable
Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
Publicidad
