Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 2,400 PSI High Pressure Washer
• Place t hehandle o ntothehandle s upports already
connected to themain unit.Make sure theholes inthe
handle a lign withtheholes onthehandle s upports
(Figure 2 ).
Align
Hol_
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the holes from the
outside of the unit and attach a plastic knob from the
inside of the unit. Tighten by hand (Figure 3).
Q
• Insert the "J"hook into the second from the left slot in
the accessory tray (Figure 4).
• Pinch the chemical hose that comes out of a hole in the
unit's base and slide it into the metal clip, as shown in
Figure 5.
• Tilt the unit up by the handle and attach the metal clip to
the rib on the left underside of the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Add Engine Oil
IMPORTANT:
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
Add Gasoline
_hL
WARNING!
Never
fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
_hL
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any fuel
spillage from engine and equipment before starting.
/
6
Publicidad
