GE 22 Manual Del Usuario E Instrucciones De Instalación página 18

Installation Instructions
INSTALLING THE WATER LINE (CONT.)
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refi'igerator back to the wall.
START THE ICEMAKER
Set the icemaker
power sudtch to the I (On)position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F (-9°C) or
below. It will then begin operation automatically if
the icemaker power switch is in the ! (On}position.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaken
REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scrawhing work surface for the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing tile hinges from
the right side to tile left side--if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Puttyknife or
thin-bladescrewdriver
5/16" Head socketdriver
3/4" Headsocket driver
(a 6-pointsocket is
recommended)
Maskingtape
18