Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Note: Some models are pre-assembled.
Assembly
is not needed on these models.
See Saw Chail7
Tg, m -iol7 AdjmtmelTt
_IbWARNING:
Cutting edges on chain
are sharp. Use protective gloves when
handling
chain.
i
iMPORTANT: Do not clamp chain saw
in vise during assembly.
J
1. Lay chain out fiat.
2. Loosen and remove guide bar nut and sprocket
cover.
3. Rotate guide bar retainer so that it is positioned
parallel to guide bar slot (see Figure 2).
4. Install guide bar onto saw body. Assemble
center slot of guide bar onto guide bar bolt
and guide bar retainer. Note: Make sure the
head of the guide bar retainer slides through
the guide bar slot as shown in Figure 2.
Drive Sprocket
Guide Bar
\
\
Guide Bar Retainer
Positioned
Parallel
to Guide Bar Slot
6.
Place chain around drive sprocket,
along top
groove of guide bar, and around guide bar nose.
Note: Make sure cutting edges of chain ale
facing
in right direction.
Position
chain so
cutting edges on top of guide bar face guide
bar nose (see Figure 4 and indicator
on side
cover of saw).
CAUTION:
Do not place chain
on saw backwards,
if chain is back-
wards, saw well vibrate badly and will
not cut.
Towards
Guide Bar
Nose
Guide Bar
Figure 4 - Saw Chain Direction
7.
Before installing sprocket cover to saw body,
turn the chain tensioning screw fully counter-
clockwise until it stops. This will position the
adjusting block towards the end of the chain
tensiong screw. (See Figure 5)
Figure 2 - Unlocking Guide Bar Retainer
5.
Rotate guide bar retainer 90 degrees as shown
in Figure 3.
Turn tensioning
screw to move
Adjustment
Block
Drive Sprocl!et
Guide Bar
Chain Tensioning
Screw
Guide Bar Retainer
Rotated 90 Degrees to
Guide Bar Slot
Figure
3 - Locking
Guide
Bar Retainer
Figure
5 - Chain
Tensioning
Screw
and
Adjustment
Block Location
10
Publicidad
