Remington RM1630U Manual Para El Usuario página 11

ASSEMBLY
8.
Pull the guide bar away fiom the saw body
so that the guide bar is fully extended and the
slack is removed fiom the chain. (See Figure
6)
10. Finger tighten the guide bar nut onto the guide
bar bolt. (See Figure 8).
Guide
Bar Nut
Figure 6 - Pulling Guide Bar
9.
Insert the sprocket cover tab into the saw body
tab slot, Step 1. Then lower sprocket cover
onto guide bar bolt, Step 2 (See Figure 7).
NOTE: At this point the sprocket cover will
not be flush against the saw body.
Figure 8 - Guide Bar Bolt
11. Slowly slide guide bar into saw body until the
adjustment block goes into the round adjusting
hole on the guide bar. (See Figure 6) NOTE:
This locks the guide bar in place. You should
not be able to push or pull the guide bar.
12. Retighten the bar nut finger tight.
13. Adjust the saw chain tension. Follow the steps
under Saw Chain Tension Adjustment..
Tab Slot Sprocket Cover Tab
Sprocket Cover Tab
Figure 7 - installing Sprocket Cover
11